Homepage » Shop » Hydrophobic coating for pebbles, mosaic tiles

Hydrophobic coating for pebbles, mosaic tiles

High-quality water-based impregnating agent for colorless impregnation of gravel, pebbles and mosaics.

from16.90 €

Loyalty program & discounts. By buying this product You would get 16.90 loyalty points. Your whole cart would be worth 16.90 loyalty points, which You could later exchange into 0.85 € discount for future orders.

About this product

The product protects the stone surface from greening, dirt, algae and moss growth, and erosion for many years. By using nanotechnology, stones used in gabions or garden architecture remain clean for a long time and retain their original appearance.By using nanotechnology, stones used in gabions or garden architecture remain clean for a long time and retain their original appearance.

Impregnation gives the stone a “lotus effect” – a hydrophobic coating that effectively protects against water, moisture, and dirt from penetrating the structure.

Areas of application:
Pebbles, gravel, stone mosaics of all colors.

Efficiency:
1 liter is enough to impregnate an area of 7-10 m².

Application method:
Spraying with a garden sprayer.

1

Provides hydrophobic properties

2

Works up to 5 years

3

Resistant to external factors, cold and UV rays

4

Dilutable (up to 1:5)

5

Does not change the color of the stone

6

Contains no silicone, wax or oils

7

VOC free

Product information

Instructions for use:
Plan the impregnation so that it does not rain for at least 3 hours afterwards. Apply only at positive temperatures on a clean and dry surface. Always start applying in a small area in an inconspicuous place – make sure the effect is satisfactory!

Cover plants and other non-impregnated areas with plastic wrap – especially glass and steel. If the product gets on such surfaces, immediately wipe it off with a damp cloth or rinse with water. The surface to be impregnated must be clean and dry.

Use a spray – apply only as much product as the stone can absorb. Spread the excess with a brush or wipe it off with a dry, clean cloth. Leave to dry (minimum 6 hours, 12 hours recommended)

NOTE: Apply one or two coats using the “wet-on-wet” method only (apply the second coat before the first one is completely dry). Wash the tools under running water.